Ultrasonic Flow Meters

20+ Years Manufacturing Experience

Support

  • Pressure and ultrasonic sensors can be used to measure the liquid level-DOF6000 open channel flow meter

    Pressure and ultrasonic sensors can be used to measure the liquid level, which is suitable for what situation? Ultrasonic sensor: measuring range 0.02-5m, can only be installed vertically; In the case of large fluid fluctuation, or fluid impurities especially much ultrasonic signal is difficult t...
    Read more
  • The Speed of Sound in Water-DOF6000 open channel flow meter

    Velocity measurements are directly related to the speed of sound in water. The factor used to scale the velocity measurement is based on the speed of sound in fresh water at 20°C (see table below). This velocity of sound gives a calibration factor of 0.550mm/sec per Hz of Doppler shift. This cali...
    Read more
  • Accuracy Considerations-DOF6000 open channel flow meter

    Alignment with Flow and Depth For the calibration to be valid, the transducer needs to be horizontally and vertically aligned with the flow. While Ultraflow QSD 6537 instruments are calibrated pointing into the flow, they can be pointed downstream with little loss of calibration accuracy. You may...
    Read more
  • TIPS for TF1100 serial ultrasonic flow meter

    1. Pipe parameters entered must be RIGHT; otherwise the flow meter will not work properly. 2. During the installation, apply enough coupling compounds in order to stick the transducer onto the pipe wall. While checking the signal strength and Q value, move the transducer slowly around the mountin...
    Read more
  • TROUBLESHOOTING for TF1100 serial flow meter

    The TF1100 ultrasonic flow meter has advanced self-diagnostics functions and displays any errors in the upper right corner of the LCD via definite codes in a date/time order. Hardware error diagnostics are usually performed upon each power on. Some errors can be detected during normal operation. ...
    Read more
  • FREQUENTLY ASKED QUESTIONS AND ANSWERS for TF1100 serial transit time ultrasonic flow meter

    Q: New pipe, high quality material, and all installation requirements met: why still no signal detected? A: Check pipe parameter settings, installation method and wiring connections. Confirm if the coupling compound is applied adequately, the pipe is full of liquid, transducer spacing agrees with...
    Read more
  • PIPE MATERIAL SOUND SPEED TABLE

    Read more
  • QSD6537 area velocity sensor ‘s develpment

    In year of 1996, we produced first generation: area velocity sensor called QSD6526 sensor . It works on ultrasonic doppler principle, it can measure flow rate by ultrasonic sensor and liquid level by pressure sensor ; It is glued structures ; Flow velocity : 21mm/s to 4500 mm/s ; Depth range: 0 t...
    Read more
  • TF1100-EC clamp on ultrasonic flowmeter COMMUNICATIONS PROTOCOL

    The TF1100 has communication protocol. Its hardware directly supports a modem, a composition of flow data monitoring system that is economical, reliable and based on telephone line transmission. It can also be connected to a RS-485 or RS232C connectors based on jumpers on circuit board for user’s...
    Read more
  • DOF6000 open channel flow meter—Instantaneous Versus “Averaged” Velocity

    from scan to scan at some sites. Because Ultraflow QSD 6537 is very sensitive to variations in velocities, you are able to see the natural velocity changes in the channel. Although the discharge in a channel may be reasonably constant for a period of time, the velocity distribution is always chan...
    Read more
  • The Ultraflow QSD 6537 requires very little maintenance. During routine site visits the following checks can be performed:

    The Ultraflow QSD 6537 requires very little maintenance. During routine site visits the following checks can be performed: Piezo Element Faces Clean the instrument surfaces where the Piezo elements are located by wiping with a cloth. If needed a plastic scraper can be used to remove any bio-...
    Read more
  • Area velocity doppler flow meter

    DOF6000 serial area velocity flow meter can monitor flow in any shapes of open channel, not full sewer or wastewater pipes without flume or weir. It is ideal for storm water, municipal water treatment and monitor, effluent, raw sewage, irrigation, running water, treated sewage water, etc . A suit...
    Read more

Send your message to us: