Ultrasonic Flow Meters

20+ Years Manufacturing Experience

Installation requirements for TF1100 series wall mounted ultrasonic flowmeters

Correct installation is the prerequisite to ensure the normal operation and accurate measurement of the TF1100-EC stationary ultrasonic flowmeter. The following are some requirements for the installation of fixed ultrasonic flowmeters:

1. Installation position

The fixed ultrasonic flowmeter should be installed in an area where the fluid flow is stable and there is no vortex and rotating flow to ensure the accuracy of the measurement. At the same time, it should avoid installation in positions that interfere with pipe bending, valves, etc.

2. Installation direction

The layout direction of the sensor should be determined in accordance with the flow direction of the fluid to ensure that the transmission and reception of the ultrasonic wave is in the direction of the flow rate.

3. Installation length

The length of the sensor layout should meet certain requirements, in general, the distance between the sensor and obstacles such as pipe bending and valves should be ensured, so as not to affect the spread and reception of ultrasonic waves.

4. Clean process before installation

Before installation, ensure the cleanliness inside the pipeline to avoid the interference of impurities and dirt on the ultrasonic wave.

5. Grounding and shielding

In order to reduce the impact of external interference, the fixed ultrasonic flowmeter should be grounded and properly shielded.

6. Temperature and pressure Factors

The temperature and pressure range of the fluid also need to be considered during installation to ensure the normal operation and service life of the flowmeter.


Post time: Jul-07-2023

Send your message to us: